Wednesday, January 26, 2011

Boot Scootin' Birdhouse

This was so cute I had to share. Link to website at the end.


Boot Scootin' Birdhouse



Add a little Western décor to your yard with this unique design.








What You Will Need:


One cowboy boot
One 1- x 2-inch 8-foot pine board
One 1- x 6-inch 8-foot rough cedar board
3 to 5 feet of sisal rope
One pair of leather bootlaces or 3 feet of leather lacing (from a craft store)
20 to 30 1- to 1-1/2-inch nails
Two 5/8-inch brass wood screws


Recommended Tools:


Saw
Screwdriver
Scissors
Hammer
Drill
Drill bits (1/16-inch and 5/16-inch)
1/4-inch hole punch

Boot Prep



Cut a 1-inch hole midway up the boot. One way to do this is to trace around a quarter. (This will create the perfect-sized hole for a wren.)


Using the hole punch, punch holes all around the opening. Make sure your holes are at least 1/8 inch away from the entrance hole to avoid tearing. Use a piece of leather lacing at least 2 feet long, and lace around the hole. To finish it, tie a double knot on the inside of the boot.


Using the hole punch, make two holes on the front and back of the boot at the top. You'll use these later.


Using a 5/16-inch drill bit, drill two to three holes in the boot's sole for drainage.


Wooden Frame Prep



To determine the correct length for your frame boards, place the pine board inside the front part of the boot. Add roughly 2 inches and cut two pieces of that length.

Cut a 45-degree angle on one end of each of these boards. (This is the hardest cut of the whole project, so if you can do this, the rest should be easy!)


From the original pine board, cut another two lengths, one 2-1/8 inch and the other 3-1/4 inch. (These will be your spacers, and you might need to adjust them for boots with wider shafts.)


Cut two 6-inch lengths of cedar from the fence board for the roof.


To assemble the frame, the 45-degree angles will face away from each other. The 2-1/8-inch piece of wood will connect the bottom, while the 3-1/4 inch spacer is roughly 8 inches above that (photos above).


To keep the boards from splitting, drill pilot holes with a 1/16-inch drill bit. Nail boards in place, using two or three nails at each connection.


Place the two cedar roof lengths at right angles. Drill and nail the two pieces together using at least six nails. Then place the roof over the frame and drill and nail into place, using at least three nails on each side.


Using the 5/16-inch drill bit, drill two holes in the roof eaves and attach a 2-foot length of sisal rope for hanging.


Put It All Together


Slide the wooden frame into the boot. Use brass wood screws to attach the boot to the wooden frame (through the holes you punched earlier). These screws won't rust, and you can easily remove them for cleaning.


Decorate any way you like. I added a bit of extra rope to mine.


To attract house wrens, hang the boot from a tree or other support about 6 to 10 feet above the ground.

http://www.birdsandblooms.com/Backyard-Projects/Birdhouses/Boot-Scootin--Birdhouse?pmcode=ILADB03V&_mid=956232&_rid=956232.666900.43575





No comments:

Post a Comment

Comments from my bloggy friends.